Mistakes to Avoid When Selecting SS 316L Flanges

Selection of the adequate flange is a very significant task in an industrial project. When the SS 316L flanges are concerned, in particular, many engineers desire an optimal combination of strength, rust resistance, and longevity. However, when making selections there are some minor errors, which may cause major troubles in the future. Whether it is a wrong size or a bad supplier selection, every mistake will bring a delay or system failure. This Great Metal blog describes the most frequent errors and the way to prevent them in order to have an easy and safe time.

Ignoring the Right Grade Requirement

Incorrect verification of whether SS 316L flanges are the appropriate grade of your job is one of the mistakes. SS 316L is well recognized due to its low carbon content which aids in corrosion reduction after welding. However, very many confuse it and equate it with ordinary SS 316.

The performance can be influenced by using a higher carbon grade where SS 316L is required. The incorrect grade is likely to wear out quicker, especially in chemical and marine industries. This is why one should be straightforward with regard to the grade. Decision-making will prevent you from harm and enhance the life cycle of the system.

Selecting Incorrect Size or Class Pressure

Many individuals overlook fitting the system with the flange size and the pressure class. This may lead to leakages, loss of pressure, or connection losses. SS 316L flanges are applied in low and high pressure pipelines. Therefore, it is dangerous to estimate the size or the class without consulting details.

Measure well. Re-check the pressure ratings. It is one step that will spare you big troubles in the future. The right flange has good sealing and easy operation particularly in those industries that use stainless steel pipe fittings or SS 316 pipe suppliers in their systems.

Purchasing of Unknown or Low-priced Suppliers

Purchasing flanges at low prices via unknown cheap sources might seem like a good idea. However, it tends to cause trouble in the long run. A lot of cheap flanges fail to pass the quality standards. They can be broken when under pressure or they might get rusted prematurely.

Establishments that people trust such as Great Metal and the best suppliers of stainless steel pipes such as their suppliers always undergo rigorous testing. They provide certificates and adequate traceability. The same way you should select good suppliers of stainless steel sheets or fasteners manufactures in India, you should select good flange suppliers who are concerned about quality.

Overlooking the Compatibility With Other Components

The other error is failure to ensure that the flange material can suit the rest of the system. As an example, SS 316L flanges are to be employed with other compatible pipes and fittings such as SS 316l pipe, ss 316l round bar or SS 316l sheet. In case of non-matched materials there is a probability that they react adversely when subjected to pressure or heat.

Welding and sealing can also be influenced by mixing wrong grades or finishes. The system is safer and more durable when there is compatibility of everything. The results are improved by matching stainless steel round bar or pipe of the same grade, to matching flanges.

Conclusion

High-quality SS 316L flanges are available at Great Metal with the expert support to make sure that you do not make expensive mistakes. Our team is going to make sure you select the right grade, size, and finish according to your particular needs. The selection of flanges is not only about the cost, but also about safety, strength, and the value of flanges that will be long-term.

We collaborate with the engineers and industries which also believe in our stainless steel pipe fittings and other stainless products. When you decide to go with Great Metal, you make a reliable decision. We will assist you to do your project the right way, all the time.